HP iPAQ h63xx

This phone has a Bluetooth® wireless implementation compatible with "Blue&Me™" device.
Phones behaviour or results may differ from those described here due to a different firmware release.

Functions Supported Dial from the car kit Yes(1) Reject incoming call Yes Redial Yes(1) User defined ring tone (kept from the phone) No Network provider name No Conference call No(2) Call waiting (second incoming call) No Caller ID as stored in the phonebook No Contacts download one by one No by selection Yes(3) fully automatic No Transfer the audio out to your phone (private call) No Muting (Local privacy) Yes SMS reader No

How to pair

Before using your mobile phone with Blue&Me™, you must create a pairing relationship between the mobile phone and Blue&Me™. After this procedure, Blue&Me™ will automatically connect to your phone each time that you enter the car and turn the car's key to the 'on' position.

To create a pairing relationship using manual interaction, follow these steps when the car is not moving:
Navigate to the Blue&Me Setup / Setup, Pairing, and then press <SRC> or <TEL>. Blue&Me™ starts the pairing procedure.
Blue&Me™ shows the mobile phone pairing PIN number on the display screen and also speaks the PIN number.

Important note

Due to its battery saving strategy (Bluetooth chipset is switched OFF after few seconds), this device has limited functionalities.
This mainly affects the calls originated from hands free while incoming calls have just a few or no limitation.

• Go to the START Menu, select SETTINGS, select CONNECTIONS tab.
• Select Bluetooth and set Bluetooth on ACTIVE.
• Select BLUETOOTH MANAGER, select CONNECTIONS tab.
• Select NEW in the lower left menu, select NEXT.
• Select "Blue&Me", select HANDSFREE UNIT, select NEXT.
• Select "Blue&Me" holding down the selection.
• From the popup menu select CONNECT.
• Enter the PIN, select FINISH.

Phonebook download

If your mobile phone doesn't support automatic downloading during phone pairing, or if you want to send individual contact entries to "Blue&Me™", the ADD CONTACTS item will be available in the USER DATA menu.
To add mobile phone contacts to "Blue&Me™" using manual interaction:
While a mobile phone is connected to "Blue&Me™", navigate to SETTINGS, USER DATA, and then select ADD CONTACTS.
Then on the mobile phone proceed as follows:

Sending contacts one-by-one

• Select CONTACTS
• Select the contact and select OPTIONS
• Select SEND, select BLUETOOTH
• Select Blue&Me

Tips & Tricks

(1) Calling number:

• Upon an incoming call, the phone doesn't pass the number of the calling party to Blue&Me™.

(2) Conference Call

• Even if the phone is expected supporting the conference call feature it never goes into the conference state. Calls are left in the active state with no possibility to toggle between them.

(3) Contacts download

• Only the contacts stored on the phone could be downloaded.